76
MV-2502-2508-08-2022
.
eeese-aircare.com © All rights reserved eeese air care a/s
UK
3. Prior to Operation
• Place the dehumidier in an upright position on a stable, at surface.
• Ensure the dehumidier is at a safe distance at least 50 cm away from a wall or furni-
ture.
• Supply power should be in correspondence with the value on the nameplate, power
outlet needs to be grounded.
• Ensure the tank is correctly tted, if the tank is full or not in place, the “tank full” light
comes on and the dehumidier will stop working.
• Turn on the power and run the machine as per instructions below.
4. Continuous Drainage
In general, water will be collected by tank, if you want continuous drainage, please do
steps as follows:
a. Remove the water tank.
b. Push a 14mm interval diameter hose on to the spout.
c. Put the water tank back in place.
Please always make sure the pipe is going downhill, and is not blocked or kinked.
To Next Page
Loading...
