eeese Otto - Operation Instructions; Switch On; Switch Off The Unit; Humidity Setting Control

MV-2552-03--2021 eeese-air-care.com © All rights eeese air care aps
77
UK
• Ensure the supply power is in correspondence with the value on the nameplate
and power outlet needs to be grounded.
• Ensure the water tank is correctly tted before the dehumidier can be switched on.
• If the dehumidier is turned o and then turned back on again immediately, it will
take approximately 3 minutes to reach full power (compressor back to work).
• If the dehumidier is switched o by a power cut, it will automatically switch back
on once the power is restored.
• The dehumidier works best at normal room temperature, its eiciency is reduced
if the ambient temperature falls to below 15°C.
• Turn on the power and run the machine as per instructions below.
5. Operation Instructions
Switch On / Switch O The Unit
1. Connect the mains lead to socket.
2. Press Power button once to turn on the unit. By default, it runs
on Manual Dehumidifying Mode.
3. Press Power button once again to turn o the unit.
Humidity Setting Control
Press Manual button once to enter Manual Dehumidifying Mode or to select desired level
of humidity from CO-30%-35%-40%-45%-50%-55%-60%-65%-70%-75%-80%-CO
Timer Setting
At ON Mode, press Timer button consecutively to select your preferred timer duration for
automatic shuto setting. Its corresponding Timer indicator will be displayed on screen.
Oscillating Flaps
Oscillating ap oscillates from dierent angle for better air circulation and optimal
diusion of the dehumidied air throughout the room.
WIFI Function
Press the Oscillation button for 2 seconds to activate the WIFI function and enter into
the distribution network mode. During the network conguration, the WIFI indicator
ashes and after the WIFI is connected, the icon is on.
See below section Connection to WIFI for detalied settings.
Press the Oscillation button for 2 seconds and you can disconnect to the WIFI.