eeese Otto - Cleaning the Air Filter Frame; Storage; Trouble Shooting

80
MV-2552-03-2021 eeese-air-care.com © All rights eeese air care aps
UK
7. Cleaning the Air Filter Frame
1. Remove the inlet frame from the back.
2. Wash the lter frame carefully in warm water, use
a mild detergent if necessary.
Note: DO NOT wash the lter frame in a dishwasher.
3. Rinse the lter frame in clean water and let it dry
before reinserting it.
4. Fit the lter frame back onto the unit
Note: DO NOT use the dehumidier without
the Air Filter Frame in place.
8. Storage
If the dehumidier will not be used for a long period of time, take the following steps:
1. Remove the plug from the socket and empty the tank, make sure the tank and the
dehumidier is completely dry. This may take a couple of days.
2. Clean the air lter.
3. Check the dehumidier for perfect condition to ensure a safe use of it after a long
period of storage.
4. Pack the device with the suitable packaging.
5. Store the dehumidier in a dust-free location, and out of direct sunlight. Preferably
covered with a sheet of plastic.
9. Trouble Shooting
Check the following before contacting technical support .
PROBLEM POSSIBLE CAUSE SOLUTION
The dehumidier
will not switch on
The power is not connected
Insert the plug into the wall
outlet and make sure the
power is on
The water tank is full Empty the tank
The tank has not been replaced
correctly
Replace the tank
The set humidity level has been
reached
Lower the humidity level
Power plug or cord damaged
Contact an authorized
service centre for repair