eeese Otto - Trouble Shooting

MV-2552-03--2021 eeese-air-care.com © All rights eeese air care aps
81
UK
Water removal
capacity is too low
Runtime is too short Be patient and wait
Ambient temperature or humidi-
ty is too low
It is normal that the device
does not dehumidify in these
conditions
The device works,
but reduces the
relative humidity
insuiciently
The room is too big
We recommend using a dehu-
midier with a greater capacity
There is too much ventilation
Reduce ventilation (e.g. close
windows and shut doors)
The air lter is clogged Clean the air lter
The humidity is higher than
the ambient humidity
Set the humidity lower than
ambient humidity
The humidity is
not reducing
The dehumidier has not been used long enough
The ambient temperature is too low
The surrounding humidity level is too low
The ambient humidity level is lower than the desired humidity
level set
The air lter frame is dirty Clean the lter frame
Dehumidier is
blowing out warm
air
The dried air is passed over
heating coils before it is blown
into the room as part of the
dehumidifying process
This is normal, a dehumidier is
not an air cooler
Water on oor
There is residual water in tank,
and the device is lurched too
much by moving
Be careful when moving the
tank
Water in tank
overows
The water tank may be
damaged.
Contact our eeese service line
Float for water auto-sensor
is not in place
Internal drainage passage
is blocked or obstructed
The dehumidier
is noisy
The air lter is blocked or the
device is on an uneven surface
Clean the lter or put the
device on a at surface
Loose or foreign particles inside
the unit
Contact our eeese service line
Sound of owing refrigerant
Error code
E1: Temperature sensor error
E2: Humidity sensor error
Contact our eeese service line