EEG HD490 - Network and Firmware Configuration

To Next Page

To Previous Page

HD490 Smart Encoder

SD/HD Encode The SD/HD Encode utility allows you to specify if SD and HD captions

are simultaneously encoded on the output video. To encode both SD and

HD captions at the same time, select ‘SD/HD Encode’ by using the UP

and DOWN buttons to scroll through the list. Choose the ‘Decoder’

option to see the captions open decoded over the video being outputted

to master video. Press ENTER to save your selection or CANCEL to

exit.

Utilities

Test Captions The Test Caption menu allows you to enable a stream of caption text on

a single 608 channel of your choosing.

 Enable starts the stream of captions on the selected channel, which

is CC1 by default. To enable test captions use the UP and DOWN

keys to select ON. To disable test captions select OFF. Use the

ENTER key to apply the changes. The test captions will stop if any

other port (i.e. 232, modem or Linux virtual port) enters caption

mode on the same channel and automatically change Enable to

OFF.

 Set Channel allows you to select which 608 channel the test caption

stream will be appear on. The default channel is CC1. TO select a

different channel use the UP and DOWN keys to select a different

channel and press the ENTER key to apply the change.

Capture VANC Captures VANC data of the selected DID/SDID from the Master video

input and loads it onto a USB storage device. Use the UP and DOWN

keys to select the desired DID/SDID and insert a USB device into the

box. Press ENTER to begin downloading the VANC data or CANCEL

to exit. To stop capturing VANC data press any front panel key.

Depending on the size and type of memory device used, there may be a

momentary delay before the device is detected. If you see “Failed: Insert

USB Disk”, wait a few seconds and try again.

Capture All VANC Captures VANC data of the selected DID/SDID from the Master video