HD490 Smart Encoder
Copyright © 2000-2012 EEG Enterprises, Inc. 36
All Rights Reserved.
Section 5: Additional Features
Set Clock <CTRL+A>c Time [Zone] [DST] <ENTER>
Sets the Encoder’s internal clock and stores the settings in Non-Volatile
Memory. If no parameters are entered, returns current settings. This
information is only used for the optional generation of the Time of Day
XDS packet.
Time is the local time on a 24-hour clock, in the format
HH:MM:SS.
Zone is the local time zone, expressed by the number of hours local
time differs from UTC time. For example, Eastern Standard Time
would be entered as 5. If the parameter is omitted, current setting
will be retained.
DST sets the Daylight Savings Time status and can be entered as
ON or OFF. If the parameter is omitted, current setting will be
retained.
Set Date <CTRL+A>d Date <ENTER>
Sets the Encoder’s internal clock for the date and stores the settings in
Non-Volatile Memory. If no parameters are entered, returns current
settings. This information is only used for the optional generation of the
Date XDS packet.
The Date parameter must be entered in the form MM/DD/YY W where
MM is the month (01-12), DD is the date (01-31), YY is the year (00-
99) and W is the day of the week (1-7, with 1 representing Sunday).
To Next Page
Loading...
