HD490 Smart Encoder
45 Copyright © 2000-2012 EEG Enterprises, Inc.
All Rights Reserved.
Appendix B: Clone Port Option
Clone Port is a factory option that configures P2 to transmit duplications
of all control commands and data that are received through the dial up
modem. This data port can then be connected to an input port on a second
Encoder. This allows two or more Encoders performing the same task to
be controlled using only one dial-up input.
When connecting two Encoders in the Clone Port configuration, always
use a Null Modem cable between the serial ports, and always make sure
that the baud rate settings of the two ports match.
Toggle Clone Port <CTRL+A>D ON/OFF <ENTER>
Toggles P2 On or Off as Clone port on a clone port enabled Encoder.
When P2 is toggled Off for Clone port, it will function normally as a
general purpose serial input port. If this command is entered without the
On/Off parameter, it will return the current P2 setting.
On a Clone port enabled Encoder, Clone port will turn on automatically
each time the unit is power cycled. P2 will not respond to input commands
when the Clone port setting is on.
To Next Page
Loading...
