HD490 Smart Encoder
Copyright © 2000-2012 EEG Enterprises, Inc. 16
All Rights Reserved.
iCap™
Every HD490 unit ships with ready-to-use iCap™ software. The iCap™
software is turned off by default. To begin using the iCap™ software,
enter your encoder’s unique iCap™ account login on the configuration
page, press ‘Apply’, and then press ‘Start’.
iCap™ account logins can be obtained by contacting EEG Sales or
Technical Support, and are now free with each HD490 unit.
For complete information on using iCap™ on the HD490, refer to the
iCap™ manual which can be found in the ‘Manuals’ section on the
configuration web pages.
Logs
The Logs tab on the HD490 web page will show daily event logs for
installed modules, including iCap™ and XDS/PSIP network insertion.
Optional Modules
A wide variety of optional modules are available for the HD490
platform. Some of the most popular are pre-installed on new units, but
require a license key to activate. See Appendix E for an up-to-date list
of available modules.
To Next Page
Loading...
