HD490 Smart Encoder
Copyright © 2000-2012 EEG Enterprises, Inc. 48
All Rights Reserved.
URL Encoding
Message Input:
Begin Message Input <CTRL+A>0 Title [Channel] [Repeat]
[K/D] [O/H] [N/L] <ENTER>
End Message Input <CTRL+C>
Transmission delay <CTRL+B> Delay (delay in seconds)
Message Input Example <CTRL+A>0 EEG_URL T2 3 D O N
<ENTER>
EEG on the Web <ENTER>
<http://www.eeg.tv>[t:p][C510]<ENTER>
<CTRL+C>
Output Message <CTRL+A>1 Title [Channel] [Repeat]
[K/D] [O/H] [N/L] <ENTER>
Remove Message from Queue <CTRL+A>4 Title [K/D] <ENTER>
Display Message Status <CTRL+A>9 [Channel] <ENTER>
Begin Set Output Queue <CTRL+A>8 [Channel] <ENTER>
End Set Output Queue <CTRL+C>
Display Output Queue <CTRL+A>B <ENTER>
Additional Features
NVM Command (Non-Volatile Memory):
New NVM Command <CTRL+A>w Port [List] Command
<ENTER>
New NVM Command Example <CTRL+A>w MA <CTRL+A>O XDS O
<ENTER>
List NVM Commands <CTRL+A>x <ENTER>
Delete NVM Command <CTRL+A>w List <ENTER>
Date and Time
Set Clock <CTRL+A>c Time [Zone] [DST]
<ENTER>
Set Date <CTRL+A>d Date <ENTER>
Prom Configurations
List PROM Messages <CTRL+A>J <ENTER>
Serial Port Configuration
Change Baud Rate <CTRL+A>I Baud Bits Parity <ENTER>
Configure GPI Switches <CTRL+A>R switch1 switch2 switch3
switch4 <ENTER>
GPI Switches Example <CTRL+A>R – b3 t2 - <ENTER>
HD490 Decoder Control
SD Decoder Control <CTRL+A>M Channel [ON/OFF]
[TON/TOFF] <ENTER>
To Next Page
Loading...
