HD490 Smart Encoder
Copyright © 2000-2012 EEG Enterprises, Inc. 4
All Rights Reserved.
LCD Screen The LCD Screen provides access to the unit’s front panel configuration
menu. On the HD490, status information is displayed when the menu is
not in use.
Control Pad The Control Pad provides menu navigation for the front panel
configuration menus. The control pad buttons are: ENTER (marked by
a check), CANCEL (marked by an ‘X’), LEFT, RIGHT, UP, and
DOWN.
USB Port The front panel USB port provides firmware upgrade capability via a
flash memory device. For instructions on upgrading the firmware, see
page 8. Additional USB ports are available on the rear panel of the unit.
To Next Page
Loading...
