Updating Your Encoder
Before updating you must first download the latest update file for your encoder model from the product updates
section of our website https://eegent.com/support/product_updates
Once you have downloaded the latest version for your encoder model you can apply it to the encoder either
through the web interface OR the front panel USB port / LCD Menu.
✔ Web Interface: Select Update from the left side menu. Browse for the update file downloaded from our
website, then click Upload, and finally click Proceed.
✔ USB / LCD: Transfer the update file to any USB stick. Insert the memory stick into the front panel USB port,
navigate to the System Setup > Update from the LCD menu, and press enter to proceed and install the
update. A message will appear on the LCD screen when the update has finished. Do not remove the
memory device while the update is running.
Some updates will require a power-cycle before they take effect; in this case, the encoder will power down
automatically once the update is complete.
Copyright © 2021 EEG Enterprises, Inc. 8
All Rights Reserved.
To Next Page
Loading...
