EemaX LavAdvantage SPEX8208T User Manual

6
3. Remove the cover. Connect the pre-assembled inlet and
outlet pipes to the heater (do not overtighten compression
fittings) and fully open the inlet and outlet ball valves.
Check the system for water leaks at all plumbing
connections. If a leak is present at the compression fitting,
slowly tighten compression nut until it stops – do not
overtighten.
4. Open the hot water faucet and run water for minimum
60 seconds and until the flow is continuous and free of air
pockets. Close the faucet and install the aerator (if
supplied).
Failure to install aerator(s) (if supplied) will result in lower-
than-expected heater performance**.
Model
# of
Aerators
Model
# of
Aerators
SPEX3512T ML
2
SPEX4208T ML
2
SPEX35T ML
2
SPEX3277T ML
2
SPEX48T ML
2
SPEX4277T ML
2
SPEX55T ML
2
SPEX8208T ML
3
SPEX65T ML
2
SPEX60T ML
2
SPEX75T ML
2
SPEX80T ML
2
SPEX95T ML
3
SPEX90T ML
3
SPEX012240T ML
3
SPEX100T ML
3
SPEX3208T ML
2
**ML thermostatic models are designed to deliver a flow of
0.35 GPM to each lavatory. Please install the supplied
aerators to ensure maximum heating performance.

EemaX LavAdvantage SPEX8208T Specifications

General

Brand	EemaX
Model	LavAdvantage SPEX8208T
Category	Water Heater
Language	English