Efco DS 2400 T User Manual

9. MAINTENANCE
Please note that the following maintenance intervals apply for normal operating conditions only. If your daily work
requires longer than normal or harsh cutting conditions are present, then the suggested intervals should be shortened
accordingly.
Complete Machine
Inspect (Leaks, Cracks, and Wear)
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x x
x
x
x
x
x
x
x
x
x
x
x
Clean after finishing daily work
Check Operation
Inspect (Leaks, Cracks, and Wear)
Inspect
Inspect (Damage, Sharpness, and Wear)
Inspect (Damage, Wear and Grease Level)
Clean
Controls (STOP button, Choke Lever, Throttle
Trigger, Trigger interlock)
Fuel Tank
Fuel Filter and tube
Cutting Attachments
Cutting Attachments Guard
All Accessible Screws and Nuts (Not Adjusting Screws)
Air Filter
Before Each Use
Monthly
As Required
6 mouths or 50 hrs.
1 year or 100 hrs.
Cylinder Fins
Starter System Vents
Carburetor
Spark Plug
Vibration Mounts
Cutting Attachments nuts and screws
DS 2400 D attachments coupling
Clean, Replace Filter Element
Check Tension
Replace
Inspect
Retighten
Clean
Clean
Clean after finishing daily work
Replace
Check Electrode Gap
Inspect (Damage, and Wear)
Replace by Dealer
Check that the locking nut of the cutting
equipment is tighten correctly
Grease
Replace
Check Idle (Cutting Attachments must not
rotate at idle)
Replace
Inspect (Damage, and Wear)
x
Maintenance Chart
Sharpen
Bevel Gear
x
Inspect (Damage, and Wear)
Starter Rope
x
If Damaged or
Faulty
33
GB

Efco DS 2400 T Specifications

General

Brand	Efco
Model	DS 2400 T
Category	Brush Cutter
Language	English