MINAC Systems Revision A
USER MANUAL 31 January 2005
63860.doc
© For reproduction rights, see cover page.
6.6 Restart after Emergency Stop Command.
Figure 13. Switches and Indicators panel, RESET button
To restart after an Emergency Stop caused by an ECU, release the emergency stop
from the ECU and press the “RESET” button on the operating panel. The unit will be
ready to receive a new power-on command.
To restart after a local Emergency switching off, follow the normal start procedure.
Refer to paragraph 6.2.
WARNING!
DANGER WHEN RESTARTING: To avoid repeating a
dangerous situation, do not restart the equipment
before finding the reason for activation of the
External Stop Command/emergency off switch and
correcting the cause.
RESET
To Next Page
Loading...