Efento SP. J.
Ul.Krupnicza 14/5
31-123 Kraków
Measurement and
transmission intervals
Configurable by user
Measurement interval: 1 minute – 10 days
Transmission interval: 1 minute – 10 days
60 000 measurements
If there is no network connection, the device buffers the
measurements in its internal memory and transfers them to the
platform once the connection is re-established. Once the memory
is full, the oldest measurements are replaced with the new ones
CoAP (RFC 7252), supports both confirmable and
non-confirmable data frames
Data is sent in Protocol buffers (protobuf)
Bluetooth Low Energy (for communication with smartphones)
Micro SIM (3FF) (default)
Embedded SIM (available on request)
APN (auto or manual)
PLMN (auto or manual)
Indicators
(troubleshooting)
LEDs singling the status of the device
Device information, which can be requested by the server
include: signal strength in dBm, total power in dBm, TX power in
dBm, cell ID, ECL, SNR, EARFCN, PCI, RSRQ, total transmitted
bytes, total received bytes, battery voltage, uptime
Diagnostics data, including the network parameters and network
connection status, is also available over Bluetooth
Enclosure material: ABS
Size: 28 x 60 x 124 mm, 110 g
Probes length (for loggers with probes only): by default 1 meter,
other lengths are available on request
Operating range: -35°C to +70°C
Mounting: double side adhesive tape with acrylic glue or 2 x M3
screws
www.getefento.com | +48 574 753 980 | efento@efento.pl
To Next Page
Loading...