Efento HC5 - Loggers Startup

Efento SP. J.
Ul.Krupnicza 14/5
31-123 Kraków
Logger’s startup
Once you insert a SIM card, switch on the device - open the enclosure and set the switch in the “ON”
position. On the device startup:
1. Red and green LEDs should blink five times,
2. After that red LED should quickly blink for a few seconds (device clears it’s memory),
3. Green LED should quickly blink for a few seconds (first transmission over NB-IoT network)
From now on, the device operates, takes the measurements and saves them in the memory.

CAUTION:
Danger of explosion if the battery is incorrectly installed. Replace only with the
same or equivalent type.
Protect the environment! Battery must be recycled or disposed of properly. Follow
your local regulations and guidelines regarding the battery disposal procedure.

www.getefento.com | +48 574 753 980 | efento@efento.pl
6