IN THE BOX
SAFETY
IT IS IMPORTANT THAT YOU OBSERVE SOME SIMPLE PRECAUTIONS BEFORE USING THIS
PRODUCT.
When installing the efergy monitor you should find that everything is relatively
straightforward. However, there are a number of important health and safety issues which
you need to be aware of.
Please read and act upon the important information on the following pages. Remember
the device is not intrusive and does not require rewiring.
In some countries (i.e Australia) the live cable can only be accessed by a qualified
electrician.
If you notice anything unusual about the electricity supply such as loose wires, exposed
cabling, burn marks, holes in the insulating materials or damage to the meter, stop
immediately and report the findings to your supply company.
Do not force or bend the cables at any point during installation. If you are worried or have
any concerns about the installation, please contact a qualified electrician immediately.
The user does not need to remove the sensor through the working life of the unit. Battery
changes are performed on the transmitter and on the display. There are no batteries to
change in the sensor.
32
Your e2 Pack contains the following
elements
1 x Sensor
1 x Transmitter
1 x Display Unit
You will need to attach the sensor to the live feed
cable which connects the meter to the consumer
unit. Any power you use in your home will pass
through this cable. The clip on sensor acts as a
current sensor, and relays the amount of current
being drawn in the home to the transmitter. From
there it is sent wirelessly to the monitor display unit,
which shows how much power is being
consumed.
It also includes
-1 x USB cable
-1 x Energy saving guide
-1 x elink software
-1 x Instruction manual for the monitor
-1 x Instructions manual for the software
Transmitter
Monitor
Sensor
To Next Page
Loading...
Need help?
Transmission
