1110
DUAL TARIFF MODE
Step 3. Single Tariff Set Up
On release you will see the symbol “TARIFF 1” flash. If you are
charged one single tariff push Mode Button to confirm. If you
have dual tariff rate, please see the following page.
Step 4. Electricity Cost
Default cost is set at 14p/kWh. This is the average price per kWh
electricity that suppliers charge in the UK. Use Up and Down
Buttons to change the cost per kWh. Press Mode Button to save
your setting and to move onto alarm setting.
Step 5. Carbon Emissions Ratio
Now set your cabon emissions ratio. This value can be increased
or decreased using Up and Down. Press the Mode Button to store
the value. The European average is 0.50 kg.CO2/kWh, this is the
default value.
Step 6. Alarm
Default Alarm is set at 5kW. If the alarm function is switched on,
and you are using more than 5kW, the alarm will sound. This value
can be decreased or increased using UP and Down Buttons. Press
Mode Button to store the value. Press Date Button to exit the
function setting mode. To activate and deactivate the Alarm at
any time push Alarm Button on the reverse of the display.
Step 1. Activation Of Dual/Multiple Tariff
Press and hold Mode Button for two seconds. On release
you will see the voltage setting flash. Press Mode twice
and you will move onto the tariff selection setting. Now you
will see the symbol “TARIFF 1” flash. Press Up or
Down Buttons to select dual or multiple tariff set up (you
can select up to 4 tariffs). Push Mode Button to confirm.
Now you have to set START and END time periods for
each tariff.
Step 2. Set Start & End Time For Tariff 1
Set the start time for TARIFF 1 first using Up or Down
Buttons. Set the hours and press Mode Button to save
and move to minute set up. Set minutes using Up or
Down and pushing Mode Button to confirm. Repeat
the process for third and fourth tariffs if you have multiple
tariff settings. You will always set one period of settings less
than the number of tariffs you have selected as the
remaining period will be saved automatically.
If you have a dual or multiple tariff rate meter you may want to set-up the dual tariff
function.
2 seconds
Throughout the set-up process, push Date Button at any time,
your settings will be saved & you will exit the function setting
mode.
To Next Page
Loading...
Need help?
Transmission
