SET-UP INSTRUCTIONS
SETTING TIME AND DATE
98
The efergy monitor needs to know the time and date in order to provide you with the
correct information.
Set the time and date as follows:
STEP 1
On the reverse of the display you will find the Time Button. Press
and hold for two seconds. Time set up will flash in the display.
STEP 2
Set the hour to the correct time by using UP and Down Buttons.
Press Mode Button once to save the hours. Repeat for
minutes, using the Mode Button to confirm.
STEP 3
Set the date by using the Up and Down Buttons. Press Mode
Button to confirm and move to month set up. Repeat the
process to set the year. Once the correct time and date have
been set, push Date Button to save and exit.
The efergy monitor needs to know unit cost per kWh charged by your electricity supplier,
along with voltage and alarm settings. The following four steps will move through each of
these settings. If you have a dual or multiple rates meter, please see overleaf.
Press and hold down Mode Button for two seconds, this will enable you to enter the setting
mode.
Step 1. Voltage
Press and hold Mode Button for two seconds. Default voltage
is set at 240V. Use Up and Down Buttons to change the
voltage. Press Mode Button to save your setting and move into
currency selection setting.
step 2. Currency Selection
Select the currency using Up and Down Buttons. Default cur-
rency will be “£”. Push Mode Button to confirm and to move
onto tariff selection set up.
Note: 20 seconds of inactivity in setting mode will return the
unit to normal display mode without saving changes.
hold for 2 seconds
hold for 2 seconds
date button to exit
To Next Page
Loading...
Need help?
Transmission
