WE RECOMMEND THAT YOUR ELECTRICITY MONITOR IS INSTALLED BY A QUALIFIED ELECTRICIAN
SETTINGS SETTINGS
13
TARIFFS
14
6. Date
The date setting is organized as dd/mm/yy.
At the top of the screen, the day will flash on
and off – use the up and down buttons to set
the day and press set before moving onto the
month and year.
3. Tariff
In the top left-hand corner of the tariff settings there are three icons, T1, T2, and T2, indicating
your tariff mode. Use the up and down buttons to toggle between the modes. If you have a
single tariff, select just T1, if you have dual tariffs select T1 & T2, if you have triple tariffs select
T1, T2 & T3.
Single Tariff
If you have a single tariff, select T1, and then use the up and down and set buttons to set your
tariff per kWh.
Dual Tariff
If you have dual tariffs select T1 & T2. First you must
set the start time for T1 by using the up and down
buttons and the set button. Repeat this process to
set the end time. The ecotouch will automatically
calculate the time remaining as the T2. You must then
set the tariff rates per kWh using the up and down and
set buttons.
Triple Tariff
If you have triple tariffs select T1, T2 & T3. First you
must set the start and end time for T1 by using the
up and down buttons and the set button. Repeat this
process to set the T2. The ecotouch will automatically
calculate the time remaining as the T3.
ALARM, TIME AND DATE
5. Time
At the top of the monitor the hours will flash
on and off, indicating that you can begin to set
the time. Use the up and down buttons to set
the hour and press set before moving onto the
minutes and then the AM/PM.
4. Alarm
In the alarm settings mode, a message will
appear asking if you wish to have the audio
alarm on or off. Use the up and down buttons
and set which option you would prefer. You
then set the value in kW that the alarm will be
set off at using up and down and set.
To Next Page
Loading...