Need help?Do you have a question about the Effekta ME 1500 and is the answer not in the manual?
Excludes liability for third-party claims, data loss, and consequential damages unless due to gross negligence.
Read and observe manual instructions before any action; work only by authorized personnel.
Transport in original packaging, store securely, avoid upside-down position.
Use in ventilated rooms, observe installation location, allow acclimatization, avoid damp environments.
Connect to earthed socket, use VDE-tested cables, ensure correct cable routing, avoid overloading.
Mains power cable must not be disconnected during operation; output may be live.
Warning: danger of electric shock/burns. Do not open, throw into fire, or mix with refuse.
Danger of electric shock even when disconnected. Isolate battery circuit before servicing.
Overview of operator control and display elements located on the front of the equipment for normal operation.
Details on warning indicators, the ON/OFF button, and device status information presented at a glance.
Specifics on the UPS ON/OFF switch and its function during startup and operation.
Explanation of Line mode LED and Support mode LED states and their meanings.
Identification and description of all connection ports and elements located on the rear of the UPS unit.
Description of the different audible warning notification sequences (A, B, C) for various UPS states.
Guidelines for storing the UPS: original packaging, temperature limits, moisture protection, and periodic operation.
Procedure for unpacking: check delivery, retain packaging for claims, and report damage immediately.
General requirements for setting up and installing the UPS, ensuring proper environmental conditions and ventilation.
Information on the plug-type connections and the connection diagram (Fig. 5).
Step-by-step instructions for safely connecting the UPS, consumer loads, and communication port.
Overview of operating modes and signals used to indicate the UPS equipment's status.
Details on Charging, Startup, On-line, and AVR modes, including their display/alarm signals.
Operator responsibilities, precautions for using controls, reading displays, and communicating with PCs.
Procedure for switching the UPS on using the front panel ON/OFF switch.
Procedure for switching off the UPS and completely deactivating it by disconnecting the mains power.
Requirement for software packages to facilitate data exchange between the UPS and a parent system.
Procedure for measuring support time, forcing UPS to support mode, and post-measurement battery charging.
Template for recording all maintenance and servicing work performed on the UPS equipment.
Contact information for the EFFEKTA service hotline via phone, fax, and email for support and safety-relevant information.
Information on EFFEKTA's maintenance services, including regular checks, installation checks, and component disposal.
Table detailing technical specifications for ME1000 and MIE1500 models, including power, input/output, and environmental data.
List of tested and approved accessories for the UPS, including software packages.
Identification of components subject to normal wear and tear, not covered by warranty.
General| Power Rating | 1500 VA |
|---|---|
| Output Power | 900 W |
| Frequency | 50/60 Hz |
| Battery Capacity | 9 Ah |
| Transfer Time | Typical 2-6 ms |
| Output Waveform | Simulated Sine Wave |
| Operating Temperature | 0-40°C |
| Output Voltage | 220/230/240 VAC |
| Battery Type | Sealed Lead Acid |
| Protection | Overload |
| Outlets | 4 x IEC C13 |
| Communication Interface | USB |
| Battery Recharge Time | 4-6 hours to 90% |
To Next Page
