Need help?Do you have a question about the Effekta Triton Series and is the answer not in the manual?
General| Category | UPS |
|---|---|
| Topology | Line Interactive |
| Operating Temperature | 0-40°C |
| Model | Triton Series |
| Frequency | 50/60Hz |
| Battery Type | Sealed Lead Acid (SLA) |
| Backup Time | Depends on load |
| Transfer Time | 2-6ms |
| Communication Interface | USB, RS232 |
| Protection Features | Overload, short circuit, over voltage, battery protection |
| Dimensions | Varies with model |
| Weight | Varies with model |
Details the validity of the manual's content regarding the UPS model.
Instructions for storing the operating manual for easy access.
Defines abbreviations, terms, and symbols used throughout the manual.
Emphasizes the importance of reading and understanding the manual for safe operation.
Outlines the terms and conditions of the product warranty.
States limitations on the company's liability for product use and manual errors.
General introduction to safety guidelines for UPS operation.
Specifies the intended and prohibited uses of the UPS system.
Critical safety measures to prevent harm to people and property.
Guidelines for environmentally friendly disposal of the UPS.
Procedures and precautions for safely transporting and storing the UPS.
Requirements for placing the UPS in a suitable environment for optimal operation.
Safety rules and procedures for connecting the UPS to power sources.
Guidelines for operating the UPS system safely.
Safety precautions when handling UPS accumulators (batteries).
Safety advice for performing maintenance and handling malfunctions.
Explains the UPS topology and its different operating modes.
Overview of different Triton series models and their components.
Detailed description of UPS modules, control panel, and interfaces.
Explains the structure and connection of the battery pack.
How to connect multiple UPS units for increased performance or redundancy.
Recommendations for storing the UPS unit before installation.
Instructions for safely moving the UPS to its final location.
Steps for safely unpacking and positioning the UPS.
Essential checks and preparations before connecting the UPS.
Requirements for the mains power supply connection to the UPS.
Measures to prevent dangerous voltages from feeding back into the mains.
Information on using an external bypass for maintenance or UPS replacement.
Recommendations for protecting loads connected to the UPS output.
Guidelines for selecting appropriate cable dimensions for output lines.
Final checks and safety measures before connecting the UPS.
General procedure for connecting the UPS system.
Detailed instructions for connecting the main terminals of the UPS.
How to connect the REPO (Remote Emergency Power Off) function.
Information on connecting SNMP, RS232, RS485, and USB interfaces.
Details on the signal interface for coupling with higher-level drives.
How to connect temperature sensors for monitoring battery bank temperature.
Instructions for connecting a relay card for UPS status monitoring.
Steps to connect an SNMP adapter for network integration.
Procedures for connecting multiple UPS units in parallel.
Basic procedures for operating the UPS system.
Step-by-step guide to power up the UPS.
Procedures for safely shutting down the UPS.
How to manually switch between INVERTER and BY-PASS modes.
How to activate the emergency power off function.
Entering and using the maintenance and service functions.
How to configure system parameters via the control panel.
Procedures for cold starting the UPS and measuring autonomy.
Steps for operating the UPS in manual by-pass mode for maintenance.
Instructions for safely replacing UPS modules.
Steps for the initial setup and configuration of a parallel UPS system.
Detailed explanation of UPS status indicators and error codes.
Contact information for technical support and service inquiries.
Procedures for replacing UPS components, especially accumulators.
Information on service contracts for ensuring UPS reliability.
Template for recording maintenance and service activities.
Technical details for connecting the relay contact extension card.
List and description of optional accessories for the UPS.
Information on external battery cabinets for extended autonomy.
Details on the SNMP adapter for network integration.
Information on the relay card for UPS status monitoring.
Description and function of the external by-pass system.
Statement confirming compliance with EU harmonized standards.
To Next Page
