What to do if my Effekta ACX11MKR2K000000 UPS shows 'Overload fault'?
If your Effekta UPS is in bypass mode with the fault LED glowing, the display showing 'Overload fault,' and an acoustic alert sounding, it means the UPS is overloaded. To resolve this, disconnect some of the connected machines from the UPS until the load display indicates 100% or less.
Why is the autonomy time lower than nominal on my Effekta ACX11MKR2K000000 UPS?
If the autonomy time of your Effekta UPS is lower than expected, it could be that the accumulators are not fully charged or some are defective. Try loading the accumulators for more than 8 hours and then retest. If the issue persists, the accumulators may need to be replaced.
How to fix an Effekta UPS with no function, display, or warning message?
If your Effekta UPS has no function, no display, and no warning message, it may not be getting power or is not switched on. Ensure all connections are correct by checking voltage measurements and switch the UPS fuse on.
What to do if connected machine does not work with Effekta UPS?
If your Effekta UPS is working but the connected machine isn't, the connection between the UPS and the machine may be defective. Check the connection and confirm it by taking voltage measurements.
What to do if Effekta ACX11MKR2K000000 UPS shows 'Temp. fault'?
If your Effekta UPS is in bypass mode, the fault LED is glowing, the display shows 'Temp. fault', and an acoustic alert is sounding, it indicates that the internal temperature of the UPS is too high. Switch off the UPS, disconnect the connected machines, and call customer service.
How to start Effekta ACX11MKR2K000000 if it doesn't start?
If your Effekta UPS cannot be started and there is no warning message, ensure that you push the ON buttons for about 2-3 seconds.
What to do if Effekta UPS shows 'Inverter fault'?
If your Effekta UPS is in bypass mode, the fault LED is glowing, the display shows 'Inverter fault', and an acoustic alert sounds, the inverter of the UPS is not operational. Switch off the UPS, disconnect the connected machines, and call customer service.
What to do if Effekta UPS shows 'DC_BUS fault'?
If your Effekta UPS is in bypass mode, the fault LED is glowing, the display shows 'DC_BUS fault', and an acoustic alert sounds, the DC bus of the UPS is not operational. Switch off the UPS, disconnect the connected machines, and call customer service.
To Next Page
General