4. Open the looper cover and clean
the looper and surrounding area
with the cleaning brush.
5. Replace the needle plate, needles
and presser foot.
Close the looper cover.
Problem Cause Reference
Needle Thread breaks The machine is not threaded correctly See pages 15-20
The thread tension is too tight See pages 20, 24-27
The needle is bent or blunt See page 12-13
The needle is not set correctly See page 12-13
A wrong needle is used See page 12-13
Needle bends or breaks The needle is bent or blunt See page 12-13
The needle is not set correctly See page 12-13
The needle clamp screw is loose See page 12-13
The fabric is forcedly pulled Do not pull the fabric
Skipped stitches The needle is not set correctly See page 12-13
The needle is bent or blunt See page 12-13
The tension is out of balance See pages 16, 19, 20
The machine is not threaded correctly See pages 15-20
Seam puckering The tension is out of balance See pages 20, 24-27
Machine does not operate The machine is not connected to the
power supply
See page 7
The foot control is not plugged in
firmly
See page 7
TRIUMPHATOR 2000X
3332
EN
USER MANUAL
To Next Page
Loading...