EFFEKTIV TRIUMPHATOR 2000X - Maintenance of the Machine; Cleaning the Feed Dogs and Looper Area

Hemming with the Cover Stitch
1. Fold up the edge of the fabric to the
wrong side and press.
2. Drawa line with a tailor’s chalk on the
right side of the fabric to mark the
fabric edge.
3. Place the fabric so the left needle
drops just to the left side of the marked
line. Lower the presser foot.
4. Sew carefully along the marked line.
5. After finishing sewing. Raise the
presser foot and remove the fabric to
the rear.
6. Draw the needle threads to the wrong
side of the fabric and knot them
together.

Marked line

Left needle

Right needle

Right side of the fabric
Triple Cover Stitch Applications
1. Hemming the sleeves

Sleeve
2. Attaching laces and tapes

Tap or lace

Right side of the fabric

Reverse side of the fabric
MAINTENANCE OF THE MACHINE
3. Attaching elastics

Right side of the fabric

Elastic

Reverse side of the fabric
4. Decorative stitch

Right side of the fabric

Reverse side of the fabric
Cleaning the Feed Dogs and Looper
Area
WARNING:
Turn the power switch off and unplug
the machine before cleaning.
NOTE:
Do not dismantle the machine in any
way other than as explained in this
section.
1. Remove the presser foot and
needles.
2. Remove the set screw and needle
plate.
3. Clean the feed dogs with a
cleaning brush.

Needle plate

Set screw

Cleaning brush
TRIUMPHATOR 2000X
3130
EN
USER MANUAL