EFI GTS - Page 6

NOTE: Letters in (parentheses) refer to the PARTS IDENTIFIER on page 3 and/or the PARTS ASSEMBLY on page 4. Use as needed for clarification.
hold
6
8
10
12
7
9
11
13
Lift
Pull
SET UP - GTS: UNFOLDING (CONTINUED)
6.
Hold the padded Center Rail Crossbar (U).
7. Hold the Tower (A), while continuing to hold the
Center Rail Crossbar (U).
8. Allow the Rails (K, N) to unfold, away from the Tower (A)
until the Rails (K, N) are fully extended. Continue holding
the Tower (A).
9-10. Raise the Rails (K, N) to level 3. Tilt Tower (A) slightly
forward, until the Support Strut Knob (M) pops into
position. Tighten Support Strut Knob (M).
IMPORTANT SAFETY CONSIDERATION: Support Strut Knob (M)
must be engaged and tightened while GTS is unfolded or
in use.
CAUTION: To avoid damage to your GTS, the Support Strut
Knob (M) must be loosened and disengaged when folding.
REPOSITIONING GLIDEBOARD
11. To reposition the Glideboard (G) for use, kneel beside the
Glideboard (G). First, lift and pop one side of the metal
Glideboard Wheel Housing (L) away from the Rails (K, N).
12. Disengage the Glideboard (G).
13. Move the Glideboard (G) about 6 inches up the Rails (K, N)
toward the Tower (A), until the metal stop on the underside
of the Glideboard (G) rests above the rubber bumper on
the Lower Rail (K). Lower the Glideboard (G) and pop the
Glideboard Wheel Housing (L) back into place.