Changing the display battery
The display can use power either from its
internal battery, or from the bike’s main
battery. The internal battery is used when
the display is disconnected from the bike,
so you can browse your ride data (like
distance, time, and average speed).
The display is powered by the bike’s
battery when connected to the bike. Even
if the internal battery in the display is dead
or not installed, the display will still operate
using main battery power. However, if you disconnect the display
from the bike, it will immediately shut off.
The display uses one CR2032 3V watch battery. It should be
available at any store that sells electronics.
To replace, unscrew the display’s back cover using a coin. Remove
the old battery, then replace with a new one, oriented as shown
(you should be able to see the + symbol on the top of the cell).
Replace the back cover, tightening about 3/4 turn until snug.
After replacing the battery, you will need to re-set the clock. Trip
time, trip distance, average speed, and max speed will also be
reset. The odometer and total time values are stored in memory and
will not be reset.
Currie Tech Technical and Customer Service: +1 800-377-4532
p. 34/52
To Next Page
Loading...