1. All work on this product (system design, installation, operation,
setting, configuration, and maintenance) must be carried out by
qualified personnel. To reduce the risk of electric shock, do not
perform any servicing other than those specified in the operating
instructions unless qualified to do so.
2. Read all instructions before installing. For electrical work, follow all local
and national wiring standards, regulations, and these installation
instructions. All wiring should be in accordance with the National
Electrical Code (NEC), ANSI/NFPA 70.
3. The battery and system can inter-connect with the utility grid only if the
utility provider permits. Consult with the local AHJ (Authority Having
Jurisdiction) before installing this product for any additional regulations
and requirements for the area.
4. All warning labels and nameplates on this battery should be clearly
visible and must not be removed or covered.
5. The installer should consider the safety of future users when choosing
the battery’s correct position and location as specified in this manual.
6. Please keep children away from touching or misusing the battery and
relevant systems.
7. Never charge a battery below the specified minimum charging
temperature or damage may occur. Please refer to this manual or spec
sheet for charging parameters.
DISCLAIMER
EG4 reserves the right to make changes to the material herein at any time without notice.
Please refer to www.eg4electronics.com for the most updated version of our manuals/spec sheets.
To Next Page
Loading...
Need help?
General
