13
A B C
1
2
4
3
Operator’s Manual Park Ranger 2150 Hedge cutter Operator’s Manual Park Ranger 2150 Hedge cutter
2.3 Start-up
1. Remove the protective cover from the cutting
bar. (Picture 1)
2. Start the machine.
3. To start the Hedge cutter, push lever D on the
right-hand side of the machine up to position 1.
(Picture 2)
4. Lower the Hedge cutter by pushing lever A
on the left-hand side of the machine down to
position 2. (Picture 3+4)
NB!
Make sure no one is standing close to
the machine while it is in use.
Protective covering
Lever D
Lever A Lever B
Wheels on surface
Operator’s manual
To Next Page
Loading...