5
Max. 10°
Ophold i knækområdet
er forbudt
Aufenthalt im Knickbereich ist verboten
Activities around the articulation point is forbidden
Ne séjournez jamais dans la zone d’articulation
1
2
3
4
Operator’s Manual Park Ranger 2150 Hedge cutter
1.1 Safety
NB
As it is articulated, the rear end of the
machine swings out when turning.
Make sure that no one stands near the
machine while it is in use.
(Picture 1)
Make sure no one stands close to
the machine while it is in use
To avoid the risk of personal injury,
stay clear of the cutting bar when it is
being lowered and tilted.
Cover the cutting bar when the
Hedge cutter is not in use or during
transport
Remove the cover immediately prior to
use. (Picture 2)
In the case of maintenance or repair,
always switch off the motor
The attachment motor must be
stopped before any adjustment,
maintenance or repair can be carried
out on the Hedge cutter.
Avoid roll-overs
Do not drive the machine in a place
where it can slide, tip or roll. Do not
drive on slopes with an incline of more
than 10 degrees. The tyre pressure
must be checked and adjusted to 1.5
bar (22 psi) when the Hedge cutter is
attached. Low tyre pressure increases
the risk of roll-overs. (Picture 3)
Transport
Only transport the Hedgecutter when
packed in transportation position.
(Picture 4)
Protective covering
Do not drive on slopes with an incline of more
than 10°
Ensure that no one stands in the working area
General information
Packed in transportation position
To Next Page
Loading...