45.
1207
1207
4-Channel, 2 W Control unit
1 Push button ON/OFF
One press turns on and the next press turns off the sound system in that zone. The current status will be showed by
the light of a red lamp.
2 Volume regulator
To turn up
or down the volume level of the control unit. The blinking light or led indicates that the volume is at
its maximum level.
3 Channel selector
This push-button enables the user to select the sound channel that will be played in a zone. Each push will change
between the available channels (up to a maximum of four), and the selection will be showed by the light of a red
lamp.
NOTE: This sound unit has an activation PIN for MILLENNIUM series amplifiers, through a DC voltage at the
speaker strip output “+”.
The control 1207 it is a digital controller and sound amplifier so it equivalent to one zone of MILLENNIUM, so it can
be controlled remotely by consoles 1202 and software 0801.
1
3
22