EasyManua.ls Logo

EGL A11 - Poor Performance at Idle and Low Speed

Default Icon
62 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TROUBLESHOOTING TROUBLESHOOTING
1. 1. Intake Manifold Inspection - Intake Manifold Inspection - Check the intake manifold seals for leaks.
Is there a leak in the manifold?
NONO - Go to STEP 2
YESYES - Loose carburetor mounting bolt (nuts).
- Damaged, cracked insulator/spacer.
- Damaged intake manifold gasket.
- Damaged O-ring seal.
- Cracked or broken intake manifold (pipe).
2. 2. Spark Test -Spark Test -Test for ignition spark by removing the spark plug and using a spark tester found at your local
auto shop or by inserting it into the spark plug cap. Place the open end of the spark plug on a metal part
of the engine and kick start the engine or use the electric start. You should see a nice blue spark on the
end of the spark plug. A faint spark will not start the engine.
Is there a good spark?
NONO - Fouled or faulty spark plug.
- Broken or shorted spark plug wire or spark plug cap.
- Broken or shorted ignition coil.
- Faulty ignition CDI box.
- Faulty or shorted magneto assembly.
- Broken or shorted engine stop switch.
- Loose or corroded wires and/or connectors (always clean bad electrical connections).
YES YES - Go to STEP 3
3. 3. CCarburetor Air/Fuel Mixture Screw Inspection - arburetor Air/Fuel Mixture Screw Inspection - Check the carburetor air/fuel mixture screw.
Turn the screw clockwise until you feel it stop. DO NOT TIGHTEN> Back out the screw counter-clock
wise 1.5 full turns.
Is the screw setting correct?
NONO - - Adjust using the above procedure or see your local EGL MotorEGL Motor dealer.
YESYES - Go to STEP 4
4. 4. Ignition Timing Inspection - Ignition Timing Inspection - See your local EGL MotorEGL Motor dealer or local motorcycle repair shop to have the
ignition timing inspected. Only attempt these procedures if you are qualied and have the proper tools
required.
Is the ignition timing normal? (Timing is not adjustable)
NONO - Faulty COi ignition box.
- Faulty ignition pulse generator.
YESYES - See your local EGL MotorEGL Motor dealer to have your motorcycle serviced.
CHECKING BRAKE PADSCHECKING BRAKE PADS
POOR PERFORMANCE at IDLE and LOW SPEEDPOOR PERFORMANCE at IDLE and LOW SPEED

Related product manuals