Ego Power+ HPW2000E - Page 14

56V LITHIUM-ION PRESSURE WASHER — HPW2000E14
PROBLEM CAUSE SOLUTION
There’s no water
spraying out.
◾ There is no water supply. ◾ Check and ensure the washer is
connected to the water supply properly.
◾ The lter is blocked completely. ◾ Clean the lter.
◾ The metal mesh in the water inlet port is
block completely.
◾ Remove and clean the metal mesh.
◾ The nozzle is blocked. ◾ Use the nozzle cleaning needle to pass
through the holes.
◾ Pump, hoses, or other components are
frozen.
◾ Wait until they are thawed.
The water ow is
not stable.
◾ Air ows into the washer. ◾ Check and ensure the siphon hose is
connected properly.
◾ Pump seals are worn. ◾ Contact EGO customer service.
The water spraying
starts or stops
automatically.
◾ The high-pressure hose is damaged. ◾ Replace with new high-pressure hose.
◾ There’s water leakage from the gun. ◾ Contact EGO customer service.
◾ Pump seals, hose seals are worn. ◾ Contact EGO customer service.
The gun cannot
control the washer.
◾ The position of the gun is beyond wireless
connection range.
◾ Take the gun closer to the pressure
washer.
◾ The coin cell (button cell) battery charge
is low.
◾ Replace with a new coin cell
(button cell) battery.
◾ The gun is not paired properly. ◾ Complete the pairing following
the instructions in the section
“ShortPressure Gun Pairing”.
◾ Coin cell battery is not installed properly. ◾ Install the coin cell battery following the
instructions in the section "REPLACING
THE COIN CELL BATTERY".