56V LITHIUM-ION PRESSURE WASHER — HPW2000E
13
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
The pressure
washer fails to be
powered on.
◾ Battery pack charge is low. ◾ Charge the battery pack.
◾ Battery pack is not installed properly. ◾ Slide the battery pack into the battery
compartment until it snaps into position.
The TURBO speed
could not be
activated.
◾ Only one battery pack is used for the washer
operation.
◾ Use two 5.0Ah or greater Ah battery
packs.
The pressure
washer pump
stops working and
the speed indicator
on the washer
ashes three
green lights.
◾ The pressure washer or the battery pack(s)
are over temperature.
◾ Wait until the pressure washer or
battery pack(s) return to the operating
temperature and then restart the
washer.
◾ The nozzle is blocked. ◾ Use the nozzle cleaning needle to pass
through the holes.
◾ No water ows into the siphon hose. ◾ Check and ensure there is water owing
into the siphon hose properly.
◾ Battery pack charge is low. ◾ Charge the battery pack.
◾ Other electronic fault(s). ◾ Contact EGO customer service.
The water ow
is low during
spraying.
◾ The lter is blocked partially. ◾ Clean the lter.
◾ The metal mesh in the water inlet port is
blocked partially.
◾ Remove and clean the metal mesh.
◾ The lter and quick-coupler joint of the
siphon hose is not fully immersed into water.
◾ Fully immerse the lter and quick-
coupler joint into water.
◾ The siphon hose is folded. ◾ Unfold the siphon hose or replace it.
◾ Water is dirty. ◾ Use only clean water.
◾ The high-pressure hose is blocked. ◾ Remove the nozzle, and then start water
spraying from the hose to clear the
blockage of the hose.
To Next Page
Loading...
