26 56-VOLT LITHIUM-ION ELECTRIC LAWN TRACTOR — TR4200E
CHARGING THE TRACTOR
Use only with the recommended battery packs and chargers.
◾
Charge the battery pack(s) separately (Fig. E7)
NOTICE: Refer to corresponding battery and charger manuals for detail instructions.
◾
Charge the battery pack(s) via charging port (Fig. E8 – E10)
TESTING THE SAFETY INTERLOCK SYSTEM
a. To test the deck-blade system (Fig. E11 – E12)
b. To test the driving system (Fig. E13 – E14)
If the deck-blade system and/or the driving system fails to stop when the operator is off of the seat and if the cause cannot be determined after
confirming the plug and socket connection of the seat is well connected, contact your EGO customer service centre immediately.
CHECKLIST BEFORE OPERATION
◾
Ensure that the work area is clear of children, bystanders, and pets.
◾
Clear the work area of objects that may be thrown by the tractor blades.
◾
Clean debris from the tractor.
◾
Check for loose fasteners.
◾
Check to make sure that all guards are in place and working properly.
◾
Visually check the tires whether they are inflated.
◾
Check the brake operation.
◾
Adjust the deck height to the desired cutting position best suited for the lawn, and adjust anti-scalp wheels accordingly.
◾
Adjust the seat position and make sure both pedals can be reached.
◾
Verify the battery charge level.
◾
Test the safety interlock system.
STARTING THE TRACTOR (Fig. E15 – Fig. E16)
WARNING: Avoid sudden starts, stops, and turns, as well as excessive speed, especially when first learning to operate the tractor. The tractor
can spin rapidly, which may cause you to lose control and result in serious injury and/or damage.
WARNING: Before starting the tractor, check and make sure the blades are disengaged within 5s when pushing the PTO switch downward. If
the blades fail to stop, do not use the tractor and contact your EGO customer service immediately.
NOTE:
◾
If the parking-brake pedal is set at the parking-brake position, you need to only press the start/stop button for 3 seconds to illuminate the
LCD screen and then release the parking-brake pedal before driving the tractor.
◾
The cutting blades can be started at any time once the LCD screen is fully illuminated and the direction control lever is not pulled backward
in the “R” direction. To turn on the blades while driving the tractor in reverse, refer to the section “TURNING BLADES ON WHILE DRIVING IN
REVERSE” in this manual.
NOTICE: Follow Fig. E17 to get the lowest driving speed until you are fully capable of operating the tractor in all situations.
The electric lawn tractor does not memorize the driving speed and blade speed settings. The driving speed and blade speed will return to level 2
every time the tractor is turned off.
Driving Speed Adjustment (Fig. E17)
Blade Speed Adjustment (Fig. E18)
LED Lights (Fig. E19)
◾
The LED headlights could be turned on and off by the LED light switch.
To Next Page
Loading...
