56V LITHIUM-ION CORDLESS CHAIN SAW — CS1600/CS1600-FC14
◾
Use only with the battery packs and chargers listed below:
BATTERY PACK CHARGER
BA1120, BA1120-FC, BA1400, BA1400-FC,
BA2240, BA2240-FC, BA2800, BA2800-FC,
BA4200, BA4200-FC, BA1400T, BA1400T-FC,
BA2800T, BA2800T-FC, BA4200T, BA4200T-FC,
BA5600T, BA5600T-FC
CH2100, CH2100-FC,
CH5500, CH5500-FC
◾
Do not charge the battery pack in rain or in wet locations.
◾
Plan the work, ensuring an obstacle-free work area and, in the case of
felling, at least one escape path from the falling tree.
◾
When felling, keep bystanders at least two tree lengths away.
◾
Do not expose a battery pack or tool to re or excessive temperature.
Exposure to re or temperature above 212 °F (100°C) may cause explosion.
◾
If situations occur which are not covered in this manual, use care and
good judgment. Contact EGO Customer Service for assistance.
KICKBACK SAFETY DEVICES ON THIS CHAIN SAW
Chain Brake
The chain saw comes equipped with a chain brake, which stops both the motor and
the motion of the chain when kickback occurs. The chain brake can be activated by
the forward motion of the chain kickback brake handle as the saw rotates backward
during kickback; it can also be activated by the inertial forces generated during rapid
pushback.
WARNING
:
Never modify or
attempt to disable the chain brake.
Make sure that the chain brake is working
properly before using the chain saw. The
chain kickback brake handle should move
back and forth easily.
To test the operation of the chain brake,
perform the following steps (Fig. 6):
6
Chain kickback brake
handle in operating position
Chain kickback brake
handle in brake position
To Next Page
Loading...
Need help?
General
