56V LITHIUM-ION CORDLESS CHAIN SAW — CS1600/CS1600-FC28
PREPARATION FOR CUTTING
Refer to “Important Safety Instructions” earlier in this manual for appropriate safety equipment.
Work Area Precautions
◾
Cut only wood or materials made from wood; do not cut sheet metal, plastics,
masonry, or non-wood building materials.
◾
Never allow children to operate the chain saw.
◾
Allow no person to use this chain saw who has not read this Operator's Manual or
received adequate instructions for the safe and proper use of this chain saw.
◾
When felling a tree, keep everyone - helpers, bystanders, children, and animals -
a safe distance from the cutting area. During felling operations, the safe distance
should be a least twice the height of the largest trees in the felling area. During
bucking operations, keep a minimum distance of 15 feet (4.5 m) between
workers. Trees should not be felled in a manner that would endanger any person,
strike any utility line or cause any property damage. If a tree does make contact
with any utility line, stay clear of the tree and the line and notify the utility
company immediately.
◾
Always cut with both feet on solid ground to prevent being pulled off balance.
◾
Do not cut above chest height, as a saw held higher is difcult to control against
kickback forces.
◾
Do not fell trees near electrical wires or buildings.
◾
Cut only when visibility and light are adequate for you to see clearly.
Proper Grip On Handles
◾
Wear non-slip gloves for maximum
grip and protection.
◾
With the saw on a rm, at surface,
hold the saw rmly with both hands.
◾
Always grasp the front handle with
the left hand and the rear handle with
the right hand.
◾
The ngers should encircle the
handle, with the thumb wrapped under the front handle (Fig. 12).
12
Grip with thumb
below handle
To Next Page
Loading...
Need help?
General
