56V LITHIUM-ION CORDLESS CHAIN SAW — CS1600 27
To Start the Chain Saw (Fig. 11)
1. Install the battery pack.
2. Make sure no objects or
obstructions are in the immediate
vicinity which could come in contact
with the bar and chain.
3. Pull the chain kickback brake
handle towards the front handle to
the operating position (Fig. 6).
4. Grasp the front and rear handles rmly, using both hands.
5. Press and hold the lock-off button with the thumb of your right hand, then squeeze
the trigger switch with the ngers of your right hand to start the saw. Release the
lock-off button and continue to squeeze the trigger for continued operation.
WARNING: Do not attempt to start the saw when the saw chain is in a cut.
To Stop the Chain Saw
1. Move the chain saw away from cutting area, and then release the trigger switch
to stop the chain saw.
2. Push the chain kickback brake handle forward to the brake position to engage the
chain brake (Fig. 6).
WARNING: Always remove the battery pack from the chain saw during work
breaks and after nishing work.
Lock-off Button
Trigger Switch
11
To Next Page
Loading...
Need help?
General
