56V LITHIUM-ION CORDLESS 20" CHAIN SAW — CS2000/CS2000-FC30
NOTE: The LCD screen lights up when trigger switch is pulled or when the speed
button or headlight/Bluetooth button is pressed. It will automatically turn off after
approximately 30 seconds of chain saw inactivity.
LED HEADLIGHT (Fig. 14)
The LED headlight is located in the front
of the chain saw housing. The headlight
provides illumination for increased
visibility and features 2 brightness levels.
To turn on the headlight, press the
headlight/Bluetooth button one time. The
headlight will turn on in low brightness
level and the LED icon
will appear
on the LCD screen. Press the headlight/Bluetooth button again to switch to high
brightness level and the LED icon will appear on the LCD screen (Fig. 13).
To turn off the headlight, press the headlight/Bluetooth button the third time and the
LED icon will disappear from the LCD screen.
OMNI-DIRECTIONAL CHAIN
BRAKE SYSTEM (Fig. 15a and
Fig. 15b)
WARNING:
The omni-directional
chain brake system is not intended to act
as a substitute to the standard/traditional
chain brake. The user should never rely on
this feature during operation of the chain
saw to protect against kickback. Always
follow safety instructions related to
kickback mitigation found in the warning
section of this manual.
The chain saw comes equipped with omni-
directional chain brake system that utilizes
onboard sensors to monitor the movement
of the chain saw and will engage the brake
if a sudden motion of the saw in the plane
of the bar is detected.
14
LED Headlight
15a
Sensors WILL detect
sudden motion in this
plane.
15b
Sensors will NOT detect
sudden motion in this
plane.
To Next Page
Loading...
Need help?
General
