56-VOLT LITHIUM-ION HEDGE TRIMMER ATTACHMENT — PTX5100
11
EN
TROUBLESHOOTING
PROBLEM
CAUSE SOLUTION
Hedge trimmer doesn’t
work.
◾ No electrical contact between the trimmer
and battery.
◾ Remove battery, check contacts and
reattach the battery pack.
◾ The battery pack is depleted. ◾ Charge the battery pack.
◾ The battery pack or tool is over-
temperature protection
◾ Allow the battery pack or power pole
to cool until the temperature drops
below 67°C.
◾ The blade is jammed. ◾ Remove the battery pack from the
tool. Remove the obstruction carefully
and then reinsert the battery and
restart the tool.
Excessive vibration or
noise.
◾ Dry or corroded blades. ◾ Lubricate the blades.
◾ Blades or blade support is bent. ◾ Replace with a new blade or support
following the section“ REPLACING THE
BLADE” in this manual or contact EGO
service center for replacement.
◾ Bent or damaged teeth. ◾ Replace with a new blade following
the section“ REPLACING THE BLADE”in
this manual or contact EGO service
center for replacement.
◾ Loose blade bolts. ◾ Tighten the blade bolts. Using a hex
wrench (not included), turn the bolt
clockwise to tighten.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.com for full terms and conditions of the EGO Warranty policy.
To Next Page
Loading...
Need help?
General
