56-VOLT LITHIUM-ION CORDLESS BRUSHLESS STRING TRIMMER — ST1510/ST1510-FC 17
ADJUSTING THE TRIMMER
HEIGHT
If the length of the shaft is not suitable for
operation, you can adjust the length of the
shaft with the height-locking clamp.
1. Remove the battery pack from the
trimmer.
2. To adjust the trimmer height, open
the height-locking clamp, and then
slide the shaft up or down to desired length, securing it in place by depressing the
height-locking clamp. (Fig.11.)
NOTICE: The loop handle may require to be readjusted after the trimmer height is
changed.
11
Height-Locking Clamp
To Next Page
Loading...
