EGO Power+ STA1500 - Troubleshooting

LINE TRIMMER ATTACHMENT — STA150012
EN
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
Line trimmer fails
to start
◾ The battery pack is not attached
to the power head.
◾ Attach the battery pack to the power head.
◾ No electrical contact between
the power head and the battery
pack.
◾ Remove battery, check contacts and reinstall the
battery pack until it snaps into place.
◾ The battery pack is depleted. ◾ Charge the battery pack with EGO chargers listed
in this manual.
◾ The lock-off lever and
trigger are not depressed
simultaneously.
◾ Press down the lock-off lever and hold it, then
depress the trigger to turn on the line trimmer.
Line trimmer stops
while cutting.
◾ The guard is not mounted on the
trimmer, resulting in an overly
long cutting line and motor
overload.
◾ Remove the battery pack and mount the guard on
the trimmer.
◾ Heavy cutting line is used. ◾ Use recommended nylon cutting line with diameter
no greater than 0.095 in. (2.4 mm).
◾ The motor shaft or trimmer head
is bound with grass.
◾ Stop the trimmer, remove the battery, and remove
the grass from the motor shaft and trimmer head.
◾ The motor is overloaded. ◾ Remove the trimmer head from the grass. The
motor will recover when the load is removed. When
cutting, move the trimmer head in and out of the
grass to be cut and remove no more than 8 inches
of length in a single cut.
◾ The battery pack or line trimmer
is too hot.
◾ Allow the battery pack or trimmer to cool until the
temperature drops below 152°F (67°C).
◾ The battery pack is
disconnected from the tool.
◾ Re-install the battery pack.
◾ The battery pack is depleted. ◾ Charge the battery pack with EGO chargers listed
in this manual.