LINE TRIMMER ATTACHMENT — STA15008
◾ Do not open or mutilate the battery. Released
electrolyte is corrosive and may cause damage to the
eyes or skin. It may be toxic if swallowed.
◾ Exercise care in handling batteries in order not to short
the battery with conducting materials such as rings,
bracelets, and keys. The battery or conductor may
overheat and cause burns.
◾ When servicing, use only identical EGO replacement
parts. Use of any other accessory or attachment may
increase the risk of injury.
◾ Battery tools do not have to be plugged into an
electrical outlet; therefore, they are always in operating
condition. Be aware of possible hazards even when
the tool is not operating. Take care when performing
maintenance or service.
◾ Do not wash with a hose; avoid getting water in motor
and electrical connections.
◾ Always wear substantial footwear and long trousers
while operating the machine.
◾ Always be sure of the footing on slopes and to walk,
never run.
◾ Save these instructions. Refer to them frequently and
use them to instruct others who may use this tool. If
you loan this tool to someone else, also loan these
instructions to them to prevent misuse of the product
and possible injury.
SAVE THESE INSTRUCTIONS
NOTE: SEE YOUR POWER HEAD OPERATOR’S
MANUAL FOR ADDITIONAL SPECIFIC SAFETY RULES.
SPECIFICATIONS
Cutting Mechanism Bump Head
Line Diameter
2.4 mm nylon
twist line
Cutting Width 38 cm
No-Load Speed 5000/6000 min
-1
Weight (Without battery pack) 1.59 kg
Measured sound power level L
WA
94.6 dB(A)
K=1.80 dB(A)
Sound pressure level at operator’s
ear L
PA
83.2 dB(A)
K= 3 dB(A)
Guaranteed sound power level L
WA
(measured according to 2000/14/EC)
96 dB(A)
Valuation of
vibration a
h
Front-assist handle
1.1 m/s
2
K=1.5 m/s
2
Rear handle
1.4 m/s
2
K=1.5 m/s
2
◾ The above parameters are tested and measured
equipped with power head PH1400E.
◾ The declared vibration total value has been measured
in accordance with a standard test method and may be
used for comparing one tool with another;
◾ The declared vibration total value may also be used in
a preliminary assessment of exposure.
NOTICE: The vibration emission during actual use of the
power tool can differ from the declared value in which the
tool is used; In order to protect the operator, user should
wear gloves and ear protectors in the actual conditions
of use.
PACKING LIST
PART NAME QUANTITY
Line Trimmer Attachment 1
Guard 1
Hex Wrench 1
Multi-Function Wrench 1
Operator’s Manual 1
About recommended cutting line, please visit the website
egopowerplus.com or refer to the EGO Product Catalogue.
To Next Page
Loading...
