Don’t Overreach – Keep proper footing and balance at all times.
If the snow blower strikes a foreign object follow these steps:
1. Stop snow blower. Release the switch.
2. Remove the battery pack(s).
3. Inspect for damage.
4. Repair any damage before restarting and operating the snow blower.
Store Idle Snow Blowers Indoors-When not in use, snow blowers should be stored indoors in dry, locked-up
place – out of reach of children.
Maintain Snow Blowers with Care – Following instructions for lubricating and changing accessories.
TRAINING
Read, understand and follow all instructions on the machine and in the manual(s) before operating this unit. Be
thoroughly familiar with the controls and the proper use of the equipment. Know how to stop the unit and
disengage the controls quickly.
Never allow children to operate the equipment. Never allow adults to operate the equipment without proper
instruction.
Keep the area of operation clear of all persons, particularly small children.
Exercise caution to avoid slipping or falling, especially when operating the snow blower in reverse.
PREPARATION
Thoroughly inspect the area where the equipment is to be used and remove all doormats, sleds, boards, wires,
and other foreign objects.
Do not operate the equipment without wearing adequate winter garments. Avoid loose-fitting clothing that can
get caught in moving parts. Wear footwear that will improve footing on slippery surfaces.
Never attempt to make any adjustments while the motor is running (except when specifically recommended by
manufacturer).
Always wear safety glasses or eye shields during operation or while performing an adjustment or repair to
protect eyes from foreign objects that may be thrown from the machine.
OPERATION
Prevent unintentional starting. Ensure the switch is in the off-position before connecting to battery pack, picking
up or carrying the appliance. Carrying the appliance with your finger on the switch or energizing appliance that
have the switch on invites accidents.
Do not put hands or feet near or under rotating parts. Keep clear of the discharger opening at all times.
Exercise extreme caution when operating on or crossing gravel drives, walks, or roads. Stay alert for hidden
hazards or traffic.
After striking a foreign object, stop the motor, remove the battery pack(s), thoroughly inspect the snow blower
for any damage, and repair the damage before restarting and operating the snow blower.
If the unit should start to vibrate abnormally, stop the motor and check immediately for the cause. Vibration is
generally a warning of trouble.
Stop the motor whenever you leave the operating position, before unclogging the auger assembly housing or
discharge chute, and when making any repairs, adjustments or inspections.
When clearing, repairing or inspecting the snow blower, stop the motor and make certain the auger assembly
and all moving parts have stopped. Remove the battery pack(s) to prevent someone from accidentally starting
the motor.
Exercise extreme caution when operating on slopes.
Never operate the snow blower without proper guards and other safety protective devices in place and working.
Never direct the discharge toward people or areas where property damage can occur. Keep children and others
away.
Do not overload the machine capacity by attempting to clear snow at too fast a rate.
Disengage power to the auger assembly when snow blower is transported or not in use.
Use only attachments and accessories approved by the manufacturer of the snow blower (such as scraper bar).
Never operate the snow blower without good visibility or light. Always be sure of your footing, and keep a firm
hold on the handles. Walk; never run.
Do not expose a battery pack or tool to fire or excessive temperature. Exposure to fire or temperature above
212 °F (100°C) may cause explosion.
Use only with the battery packs and chargers listed below:
To Next Page
Loading...
Need help?
General
