BATTERY PACK CHARGER
BA1120, BA1120-FC, BA1400, BA1400-FC, CH2100, CH2100-FC,
BA2240, BA2240-FC, BA2800, BA2800-FC, CH5500, CH5500-FC,
BA4200, BA4200-FC, BA1400T, BA1400T-FC,
CH2800D, CH2800D-FCBA2800T, BA2800T-FC, BA4200T, BA4200T-FC,
BA5600T, BA5600T-FC
NOTICE: For best performance, recommend for use with 2pcs 5.0Ah or higher Ah batteries.
CLEARING A CLOGGING CHUTE
Hand contact with the rotating auger assembly inside the discharge chute is the most common cause of injury
associated with snow blowers. Never use your hand to clean out the discharge chute.
To clear the chute:
SHUT THE MOTOR OFF!
Remove the battery pack(s) from the snow blower.
Wait 10 seconds to be sure the auger has stopping rotating.
Always use the chute clean tool which is attached to the machine as an accessory, do not use your hand.
MAINTENANCE AND STORAGE
Check all bolts or fasteners at frequent intervals for proper tightness to be sure the equipment is in safe working
condition.
Always refer to operator’s manual for important details if the snow blower is to be stored for an extended period.
Maintain or replace safety and instruction labels, as necessary.
Run the machine a few minutes after blowing snow to prevent freeze-up of the auger assembly.
SAVE THESE INSTRUCTIONS. Refer to them frequently and use them to instruct others who may use this tool. If
you lend this tool to someone else, also lend these instructions to them to prevent misuse of the product and possibly
injury.
INTRODUCTION
Congratulations on your selection of a new generation of 56V Lithium-Ion powered snow blower. It has been
designed, engineered and manufactured to give you the best possible dependability and performance. Should you
experience any problem you cannot easily remedy, please contact EGO customer service center 1-855-EGO-5656.
This manual contains important information on to the safe assembly, operation and maintenance of your snow
blower. Read it carefully before using the tool. Keep this manual handy so you can refer to it at any time.
SERIAL NUMBER______________________ DATE OF PURCHASE_ _________________ THE MODEL AND
SERIAL NUMBERS WILL BE FOUND ON A LABEL ATTACHED ON AUGER
ASSEMBLY HOUSING. YOU SHOULD RECORD BOTH SERIAL NUMBER AND DATE OF PURCHASE AND
KEEP IN A SAFE PLACE FOR FUTURE REFERENCE. SAVE YOUR SALES RECEIPT.
SPECIFICATIONS
Voltage 56V
Clearing Width 24 in
Intake Height 20 in
Throwing Distance Up to 50 ft.
Wheel Size 15 in
Operating Temperature -4°F-50°F(-20°C-10°C)
Storage Temperature
-4°F-158°F(-20°C-
70°C)
Snow Blower Weight (Without battery pack) 143.3 lbs (65 kg)
To Next Page
Loading...
