56
FIRST STEPS & GETTING STARTED
FIRST STEPS AND GETTING STARTED
1. CHARGING THE BATTERY
Note that for safety reasons the scooter is
delivered with a low charge. This is why it
is a good idea to charge the scooter after
receiving it.
To charge, turn the protective cover to the
side (EGRET-TEN) or remove the plastic
plug from the charging socket (EGRET
EIGHT).
The charging socket is located on the front
right frame of the EGRET-TEN and on the
front left of the EGRET EIGHT.
First connect the charger to the power
socket. Then connect the charging cable to
the port on the scooter. Make absolutely
sure that the scooter cannot tip over on the
plug.
Never charge unattended, ideally on a fi re-
proof, non-conductive surface.
1
2
EIGHT
EIGHT
TEN TEN
To Next Page
Loading...
