Egret Pro - Menu Item Functions

60
Menu items
SET1:PINlockon/o To activate the PIN lock, press the ‘Plus’ or ‘Minus’ button.
SET2:ChangePIN Press the ‘Plus’ or ‘Minus’ button to enter change mode.
The process for changing the numbers is the same as when
the scooter is started for the rst time. (see page 46)
SET3:km/hormph To switch between km/h and mph, press the ‘Plus’ or ‘Minus’
button.
SET4:Bluetoothpairing To activate Bluetooth pairing, press the ‘Plus’ or ‘Minus’ button.
It remains active for 5 minutes. Note: If you leave the settings
menu, the Bluetooth pairing is switched off.
SET5:Bluetoothon/o Default setting: The Bluetooth interface is active.
Press the ‘Plus’ or ‘Minus’ button to switch it off.
SET6:Displaybrightness When the light is switched off, the brightness is always set
to 100%. When switching on the light, the brightness of the
display is automatically dimmed. In the menu you can set how
much the display should be dimmed. To do this, press the
“plus key” for a brighter display and the “minus key” for a
darker display.
Notes: The light should be activated before the settings are
changed. This is the only way to see the set brightness.
SET7:Pedestrianmode The scooter has a pedestrian mode. Activate the mode so
that the scooter moves at walking speed. Press the “plus key”
or “minus key” to exit pedestrian mode.