ehb electronics HC 960 - Parameter Programming and Termination; Programming Procedure; Termination of Programming

HC960 Operating Instructions
5/14 Version 2.1 © ehb Errors excepted
 Y:\Vertrieb\01 Produkte\01 Produktinformationen Vertrieb\HC 960\Betriebsanleitung\HC 960_BA_V2.1_EN_23.11.2020_.docx
Bedienungsanleitung.doc • Stand/Version: 25.02.2005/00 • Layout: Gottschalk • \\Ehelec-nts-000\EHELEC\Iso 9001\Formblätter\Vorlagen
4. Programming the parameters
The parameters must always be programmed when the machine is at standstill. To access the parameter
setting in operating mode, switch on the device while holding down the set button. Press the set button
until the display shows "*** parameter ***". Use ↙ and ↗ to scroll to the desired parameter. Use "set" to
be able to change the parameter. Afterwards the value can be adjusted with ↙ and ↗ and saved with
"set".
Termination of programming
If programming is terminated by switching off the device, all changes made since the last time the set but-
ton was pressed are retained.