Ei Electronics Ei207 Series Instruction Manual

15
2.2 Mounting the Alarm
WARNING: The installation of this CO Alarm is not a substitute for proper installation, use
and maintenance of fuel burning appliances including appropriate ventilation and exhaust
systems.
2.2.a Installation Procedure
1. Select a location complying with the advice in ‘Where to locate the CO Alarm’.
2. Remove the mounting plate from the packaging/Alarm.
3. Place the mounting plate on the ceiling/wall exactly where you want to mount the
Alarm. With a pencil, mark the location of the two screw holes.
4. Taking care to avoid any electrical wiring in the
ceiling, drill holes using a 5.0mm drill bit through
the centre of the marked locations. Push the
plastic screw anchors provided into the drilled
holes. Screw the mounting plate to the ceiling/
wall. If wall mounting the CO Alarm, the panel
pin may be used as an alternative to the screws,
provided it is suitable for the mounting surface.
5. Alternatively, if desired, the CO Alarm will also free stand on a flat surface with the
mounting plate attached.
6. If using the RadioLINK interconnection, ensure the RF module is fitted correctly into the
base of the Alarm. For further advice on the RadioLINK installation, read the manual of
the RadioLINK module.
wall
panel pin
mounting pad
Alternative Mounting pin

Ei Electronics Ei207 Series Specifications

General

Brand	Ei Electronics
Model	Ei207 Series
Category	Security System
Language	English