Ei Electronics Ei207 Series User Manual (English)

Other manuals for Ei Electronics Ei207 Series

Instructions For Use56 pages

Instruction Manual36 pages

Questions and Answers:

S
Shannon LeAug 17, 2025
Why my Ei Electronics Carbon Monoxide Alarm doesn't sound when I press the test button?
- J
  Jamie ClarkAug 17, 2025
  If your Ei Electronics Carbon Monoxide Alarm doesn't sound when you press the test button, ensure the alarm is correctly secured on the mounting plate. Wait 15 seconds after connecting the power before testing. Press and hold the button firmly for at least 5 seconds. If you have Ei207 models, replace the batteries. If the alarm still doesn't sound after these steps, it should be returned for repair or replacement.
L
Leah WallsAug 21, 2025
What to do if Ei Electronics Carbon Monoxide Alarm has sensor fault?
- K
  kpalmerAug 21, 2025
  If your Ei Electronics Carbon Monoxide Alarm detects a sensor fault, it will emit 2 short beeps accompanied by 2 yellow LED flashes approximately every 48 seconds. When this occurs, the alarm must be replaced. If immediate replacement is not possible, you can press the test button to silence the sensor fault beeps for 12 hours. Note that the sensor fault can only be silenced once.
A
Anna BushAug 26, 2025
Why does my Ei Electronics Carbon Monoxide Alarm chirp/beep?
- J
  Jennifer FernandezAug 27, 2025
  In standby mode, the Ei Electronics Carbon Monoxide Alarm should not sound, beep, or chirp; only the green power LED should flash. The alarm automatically checks the battery, sensor, and electronics periodically. If a fault is detected, the alarm will alert you with short chirps and a flashing yellow LED every 48 seconds. Faults will also be indicated when the test button is pressed.
M
matthew58Sep 3, 2025
What to do if the Ei Electronics Security System alarm does not work with the test button?
- M
  Mrs. Crystal Ramirez MDSep 3, 2025
  If your Ei Electronics Security System alarm doesn't respond to the test button, first ensure the alarm is correctly secured on the mounting plate. After connecting the power, wait 15 seconds before testing the button. When testing, hold the button down firmly for at least 5 seconds. If you have an Ei207 model, try replacing the batteries.